Power Amplifiers - PE Series
Features
- Rugged, road worthy professional power amplifier. E.I.A. Standard 19" (48.3 cm) rack mountable chassis.
- PE Series "Class H" circuitry generates large voltage swings while avoiding electrical stress on the output stages. This results in low distortion and high reliability.
- Front panel power switch with turn-on-delay for loud speaker protection.
- Patented output device emulation protection keeps the amplifier working under extreme conditions.
- High damping factor provides superior control over low frequency drivers for a clean, accurate low end.
- Safe with any load. Bridge-mono and Parallel-Mono modes offer optimal load-matching performance.
- Complete protection against shorted outputs, mismatched loads, overheating, DC input/output and high frequency overload, full internal fault protection.
- Selectable low frequency from 80Hz to 250Hz
Specification
| Model | PE400 | PE600 | |
| Stereo Power 1 KHz 0.1% THD | 8Ω | 300W | 450W |
4Ω | 450W | 700W | |
| Bridge mono power 1 KHz 0.1% THD | 8Ω | 900W | 1400W |
| Parallel mono power 1KHz 0.1% THD | 8Ω | 300W | 450W |
4Ω | 450W | 700W | |
| Full bandwidth | 20Hz-20KHz+/-0.5dB | ||
| Frequency Response | +0dB/-0.3dB from 20Hz to 20kHz at 1 watt | ||
| Phase response | +/-0.1 degrees from 10Hz to 20kHz at 1 watt | ||
| S/N | >98dB | ||
| IMD | ≤ 0.01% Rated Power @ 8Ω | ||
| THD | ≤ 0.01% Rated Power @ 8Ω 1kHz | ||
| Damping Factor | > 500@ 1kHz/8ohms | ||
| Cross Talk | > 50 dB | ||
| Slew Rate | 45v/ μS (Stereo) | ||
| Input impedance | 10K/20K ohurs, unbalanced or balanced | ||
| Dimensions (mm) | 483 x 400 x 89 mm | ||
| Main power supply | ~240V 50/60Hz Fuse:T8A | ~240V 50/60Hz Fuse:T10A | |
| N.W | 15.3 kg | 19.3kg | |
| W.G. | 17.0kg | 21.0kg | |